Voodoo Lab Pedal Power 2 Plus
120 VAC North American version.  Latest model... PP2 "Plus"!  The Voodoo Lab Pedal Power 2 Plus power supply can handle most any situation possible and comes with an assortment of power cables.  The Pedal Power 2 Plus is hand made in the U.S.A. and carries a 5-year warranty. It features a toroidal transformer and completely isolated outputs to insure noise free operation.  We stock a huge selection of extra cables.  See below for cables.  List: $240.00, our price is only $169.95   More Info

Voodoo Lab Pedal Power AC
120 VAC North American version.  The Voodoo Lab Pedal Power AC is a pedalboard power supply desingned to operate high current and AC powered pedal effects. Finally a professional solution for powering tube overdrives, modeling pedals or devices including the Whammy, POD, Rotosphere and many others without wall warts. The Pedal Power AC provides two 9VAC and two selectable 9VAC or 12VAC outputs. It features a toroidal transformer and completely isolated outputs to insure noise free operation. List: $200.00, our price is only $139.95   More Info

Dunlop/MXR DC Brick
The DC Brick is the most reliable and consistent way to power your effects board. Forget the collection of unsightly wall warts ... the DC Brick will drive ten pedals or stomp boxes from the same source! More than a power supply, this box is a power conditioner as well. Unlike aging batteries, the Brick supplies predictable voltage at all times, keeping your effects consistent from show to show. Its FCLC (Foldback Current Limiting Circuit) provides ultimate protection against power shorts and overloads. Even at full load, you'll enjoy the quiet and cool operation of a fully regulated power supply. But since battery-powered effects rarely exceed 30 milliamps each, you're not likely to use anywhere near the Brick‘s capacity of 1000 milliamps output! Power: Included AC power adapter can utilize a wide range of international wall power from 100 to 240 volts, at 47 to 63 Hz. Supplied with U.S. plug. Controls: - Power Input from AC Adapter (Use only the included adapter!) - Seven 9V outputs can handle an average of 55 milliamps each, or a total of 375 milliamps in any configuration Three 18V outputs can handle an average of 208 milliamps each, or a total of 625 milliamps in any configuration All outputs may be used simultaneously for a total power output of up to 1000 milliamp

* Seven 9V outputs can handle an average of 55 milliamps each, or a total of 375 milliamps in any configuration
* Three 18V outputs can handle an average of 208 milliamps each, or a total of 625 milliamps in any configuration
* All outputs may be used simultaneously for a total power output of up to 1000 milliamp

Add to Cart

List Price: $190.95
Our Price: $99.95 

Godlyke Power All - PA-9
A simple, effective and most affordable method for powering your 9-volt effect units. The 1.7 Amp current capability can power over twenty 9-volt effects. Includes Cable-5 daisy chain connector and assorted jumper cables to power phone plug, reverse polarity, battery-only, and Line 6 units. Extra standard and custom cables are available. List: $45.00, our price is only $39.95  See all the Power-All products:

PA-9 | PA-9 Euro | PA-9 UK | PA-9 Cables | Travel Adaptor Kit

Cables for Power Supplies
A vast selection of stock or custom lengths, plugs, polarities and configurations to suit most any application. Includes the standard 2.1mm Boss type plugs, reversed 2.1mm plug, Y-cables for powering 2 - 9 volt pedals using only 1 output, 18 volt cables to power one 18 volt pedal using 2 outputs, Line6 cables, 3.5mm mini plug cables, extension cables; reversed extensions, bare wire for DIY applications and more. We support many power supplies including cables for:

Pedal Power 2 Plus  •  Pedal Power AC
MKS Power Pad  •  Power All